300mm pedestrian light with countdown timer traffic lights

First, the 300mm pedestrian light with countdown timer traffic lights parameter details:

Model: WDM-DJ300-05 Mainly used in driving schools, crossroads and other places.

1. Product size: 1050*350*110mm (without decorative edge)

2. Number of lamp beads: 65 reds, 120 greens

3. Lightning diameter: 300MM

4. Lamp Beads Category: Taiwan Crystal Chip Lamp Beads

5. Red wavelength: 620-625NM

6. Green wavelength: 500-505NM (blue-green) 520-525NM (green)

7. Visual distance: ≥1000M

8. Service life: 100000H

9. Shell material: PC

10. Illumination angle: 30°

11. Working temperature: -40 ° C -65 ° C

12. Protection level: IP53

13. Working voltage: AC85V-265V A small amount of DC12V/24V

14. Rated power: red 18W green 22W

15. Installation method: horizontal or vertical

Second, 300mm pedestrian light with countdown timer traffic lights features:

1.300mm pedestrian light with countdown timer traffic lights adopt Taiwan wafer chip lamp beads, high

brightness, high refresh rate and long service life.

2. 300mm pedestrian light with countdown timer traffic lights on the back of the design with outlet holes,

not only easy to outlet, but also has a good waterproof effect.

3. 300mm pedestrian light with countdown timer traffic lights sunshade cover made of PC material, with

good waterproof and dustproof effect, easy to install.

4. 300mm pedestrian light with countdown timer traffic lights for each lamp and lamp. This is a snap-on

design, which is convenient for product inspection and maintenance.

Third, 300mm pedestrian light with countdown timer traffic lights installation:

Installation method: horizontal installation

1. Leave a screw on both ends and unscrew the nut on the screw.

2. Place the “L” bracket on the flat end and tighten the nut according to the hole position and the slot on the

screw.

3. The sun visor is installed on the upper part of the lamp. The three-corner aluminum plate is folded into

a circular arc shape, which is placed on the lamp and screwed to the corresponding hole to tighten.

4. Make 2 holes on the signal light rod, drill holes according to the hole position of the L bracket of the

signal, pass the light rod through the appropriate screw, and put the L-shaped bracket on the screw and

fix it with the nut. (as the picture shows)

Installation method: erect installation

Erect the installation and the steps of the installation, just stand up and pay attention to 2 points:

1. The visor is at the top of the lamp

2. The outlet hole is facing down

Countdown signal related recommendations:

1, double 8 countdown timer traffic signal light

2, single 8 countdown timer traffic signal light

3, 300mm red and green belt countdown timer traffic signal light

4, 400mm left turn arrow red yellow green traffic signal light, etc.

If you are interested in our product,Please fell free to contact with us