6 leds Round shape solar spike led road stud

6 leds Round shape solar spike led road stud

The product parameters of the round solar road spike:
1. Product model: WDM-DD06-C-10R
2. Product size: 120*120MM
3. Lamp color: red, yellow, blue, green and white
4. Number of lamp beads: 10
5. Red wavelength: 620-625NM
6. Yellow wavelength: 590-595NM
7. Blue wavelength: 470-475NM
8. Green wavelength: 520-525NM
9. White brightness: 18900-22600MCD
10. Protection level: IP68
11. Shell material: plastic
12. Battery voltage: 1.2V
13. Solar panel: 2.5V
14. Working temperature: -40 ° C ~ 60 ° C
15. Working mode: light control (normal flash / always bright)

The characteristics of the round solar road stud:
1. round solar road stud are mainly used for fishing boats, docks, and can also be used for landscape lights in Christmas trees, villas, residential

areas, garden small courtyards, outline roads, and have various uses.
2. The round solar road stud adopts 0.25W/2V monocrystalline silicon solar panel. Monocrystalline silicon is a relatively active non-metallic

element. Besides the general characteristics, it also has the advantages of high purity and high solar energy conversion rate.
3. The solar panels of the round solar road stud are embedded in the PC frame to better absorb solar energy without being damaged by the car.
4. The round solar road stud are made of super-bright Taiwanese wafer chip bead. The color is conspicuous and the color is clear. It has good

visual performance both during the day and at night, which can cause the driver’s attention and reduce the speed. Improve driving safety on

highways.
5. round solar road stud are available in a variety of colors, and the bead color can be customized according to customer requirements.

6. Round solar spikes have over-charge and over-discharge protection.
7. The round solar road spike has good waterproof and dustproof effect and the protection grade can reach IP68.

The installation steps of the round solar road spikes:
1, installation instructions:
Roadside line (not recommended to be installed in the middle of the road to avoid excessive impact on the car, resulting in damage to the spike)
2, the installation steps:
1> Positioning: Firstly use the ruler to determine the installation position, ensure that the longitudinal position of each position is in a straight

line, the installation distance and design requirements shall prevail, and the installation site shall be flat, dry, clean and seamless.
2> Mixing glue: special glue for road nails, special glue for road nails, and the ratio of glue B for glue A is 1:1 (such as: 1 kg for A glue and 1 kg for

B glue). The glue must be evenly mixed and the color is consistent.
3>Glue: When installing, the road surface should be cleaned. Use glue to be moderate. Stick to the bottom of the spike and do not overflow too much.

About 40-50 grams of glue should be used for each spike to apply glue to the bottom of the road sign. Place it in a pre-planned position. Clean the road

debris after installation.
4> Tour: Check the installed spikes after two hours.
5> Road closure: It is recommended to seal the road for 6 hours to ensure the curing time of the glue.

We recommended some other models of solar road stud as below:

If you are interested in our product,Please fell free to contact with us