12 inch PC Traffic Signal Accessories red yellow green 300mm traffic light

12 inch PC single Traffic Signal Accessories 300mm traffic light

The parameters of the red yellow green 300mm traffic light:
Product model: WDM-JD300-3-RYG
1. Product size: 1050*350*110mm (without decorative edge)
2. Number of lamp beads: 156 red, yellow and green
3. Lightning diameter: 300MM
4. Lamp Beads Category: Taiwan Crystal Chip Lamp Beads
5. Red wavelength: 620-625NM
6. Yellow wavelength: 590-595NM
7. Green wavelength: 500-505NM (blue-green) 520-525NM (green)
8. Service life: 100000H
9. Shell material: PC
10. Illumination angle: 30°
11. Working temperature: -40 ° C -65 ° C
12. Protection level: IP53
13. Working voltage: AC85V-265V A small amount of DC12V/24V
14. Rated power: red and yellow each 18W green 22W
15. Installation method: horizontal or vertical
16. Visual distance: ≥1000M

Second, the characteristics of the red yellow green 300mm traffic light:
1.red yellow green 300mm traffic light use Taiwan crystal chip lamp beads, high brightness, high refresh rate, long service life.
2.red yellow green 300mm traffic light on the back of the design of the outlet hole, not only easy to outlet, but also has a good waterproof effect.
3.red yellow green 300mm traffic light sunshade is made of PC material, which has better waterproof and dustproof effect and simple installation.
4.red yellow green 300mm traffic light each of the lights and lights with a snap-on design, convenient for product inspection and maintenance.

Third, 300 type full red, yellow and green three lights installation method:
Installation method: horizontal installation
1. Leave a screw on both ends and unscrew the nut on the screw.
2. Place the “L” bracket on the flat end and tighten the nut according to the hole position and the slot on the screw. (as the picture shows)
3. The sun visor is installed on the upper part of the lamp. The three-corner aluminum plate is folded into a circular arc shape, which is placed on the

lamp and screwed to the corresponding hole to tighten.
4. Make 2 holes on the signal light rod, drill holes according to the hole position of the L bracket of the signal, pass the light rod through the appropriate

screw, and put the L-shaped bracket on the screw and fix it with the nut. (as the picture shows)
Installation method: erect installation
The same steps as erecting and traversing, just stand upright,
Pay attention to 2 o’clock,
1. The sun visor is on the upper part of the lamp 2. The outlet hole is facing down (as shown)