Product model: WDM-JD200-2-RG
1. Product size: 500*250*155MM
2. Lamp color: red green
3. Lamp Bead Category: Taiwan Crystal Chip Lamp Beads
4. Lightning diameter: 200MM
5. Number of lamp beads: 90 red and green
6. Red wavelength: 620-625NM
7. Green wavelength: 500-505NM (blue-green)
8. Installation method: horizontal or vertical
9. Shell material: PC
10. Working voltage: AC85V-265V A small amount of DC12V/24V
11. Working temperature: -40 ° C ~ 65 ° C
12. Protection level: IP53
13. Illumination angle: 30°
14. Visual distance: ≥1000M
15. Service life: 100000H
16. Rated power: 8W for red and green
The characteristics of the 200mm red green pc traffic light:
1. 200mm red green pc traffic light use Taiwan crystal chip lamp beads, high brightness, high refresh rate, long service life.
2. 200mm red green pc traffic light on the back of the design has a wire hole, which is not only convenient for outlet, but also has a good waterproof effect.
3. 200mm red green pc traffic light is made of PC material, which has better waterproof and dustproof effect and simple installation.
4. 200mm red green pc traffic light are installed with L-shaped brackets, which is very convenient to assemble.
The physical map of the 200mm red green pc traffic light:
Fourth, the installation method of 200mm red green pc traffic light:
Installation method: horizontal installation (1) A screw is left at both ends, and the nut above the screw is unscrewed.
(2) Place the “L” bracket, the flat end, on the screw according to the hole position and the slot, and tighten the nut. (as the picture shows)
(3) The sun visor is installed on the upper part of the lamp. The visor is placed on the lamp and screwed to the corresponding hole to tighten.
(4) Make 2 holes on the signal light rod, drill holes according to the hole position of the L bracket of the signal, pass the light rod through the appropriate screw, and put the L-shaped bracket on the screw and fix it with the nut. (as the picture shows)
Installation method: Horizontal or vertical installation
1. The visor is at the top of the lamp
2. The outlet hole is facing down (as shown):4[LZZ{41.jpg)
1.Voltage:DC12V/24V:
(1) red and black lines - red light negative;
(2) red line - positive electrode;
(3) Green line - green light negative;
2. Voltage:220V:
(1) Black line - public zero line;
(2) Red line - red light line;
(1) Lamps: 1 set (2) Visor: 2 (3) L-type bracket: 2 (4) Instruction manual: 1 copy (5) Certificate of conformity: 1 part (6)
Post time: Mar-27-2019