double-sided 6-lamp solar road stud
product parameters for the double-sided 6-lamp solar road stud :
1. Product model: WDM-DD01-2-6Y
2. Product size: 105*105MM
3. Lamp color: red, yellow, blue, green and white
4. Number of lamp beads: 6
5. Red wavelength: 620-625NM
6. Yellow wavelength: 590-595NM
7. Blue wavelength: 470-475NM
8. Green wavelength: 520-525NM
9. White brightness: 18900-22600MCD
10. Protection level: IP68
11. Shell material: cast aluminum
12. Battery voltage: 1.2V
13. Solar panel: 2.5V
14. Working temperature: -40 ° C ~ 60 ° C
15. Working mode: light control (normal flash / always bright)
Second, the characteristics of double-sided 6-lamp solar road stud:
1. double-sided 6-lamp solar road stud adopts 0.25W/2V monocrystalline silicon solar panel. Monocrystalline silicon is a relatively active
non-metallic element. Besides the general characteristics, it also has the advantages of high purity and high solar energy conversion rate. .
2,double-sided 6-lamp solar road stud are designed with aluminum casing, which is strong in impact resistance and durable. The solar
panels are embedded in an aluminum frame to better absorb solar energy without being damaged by car crushing.
3,double-sided 6-lamp solar road stud use super bright Taiwan crystal chip light beads, the color is eye-catching, the color is clear, whether
it is good visibility during the day or night, can cause the attention of the driver. Reduce the speed of the car and improve the driving safety
on the highway.
4, double-sided 6-lamp solar road stud are available in a variety of colors, the color of the lamp beads and reflectors can be customized according
to customer requirements.
5, double-sided 6-lamp solar road stud have over-charged and over-discharged protection functions.
6, double-sided 6-lamp solar road stud has a good waterproof and dustproof effect, the protection level can reach IP68.
1, installation instructions:
Roadside line (not recommended to be installed in the middle of the road to avoid excessive impact on the car, resulting in damage to the road stud)
2, the installation steps:
1> Positioning: Firstly use the ruler to determine the installation position, ensure that the longitudinal position of each position is in a straight line, the
installation distance and design requirements shall prevail, and the installation site shall be flat, dry, clean and seamless.
2> Mixing glue: special glue for road nails, special glue for road nails, and the ratio of glue B for glue A is 1:1 (such as: 1 kg for A glue and 1 kg for B glue).
The glue must be evenly mixed and the color is consistent.
3>Glue: When installing, the road surface should be cleaned. Use glue to be moderate. Stick to the bottom of the spike and do not overflow too much.
About 40-50 grams of glue should be used for each spike to apply glue to the bottom of the road sign. Place it in a pre-planned position. Clean the road
debris after installation.
4> Tour: Check the installed spikes after two hours.
5> Road closure: It is recommended to seal the road for 6 hours to ensure the curing time of the glue.
In addition to the double-sided 6-lamp solar road stud, We also produces other road stud.
1. Plastic Road Stud
2. Highway mechanical and electrical products
3. Construction guide card
4. Solar transportation products, etc.
Post time: Mar-01-2020