4 Pain Points of good quality aluminium led solar road stud flashing
First, why the good quality aluminium led solar road stud flashing do not light up after a period of use?
Friends who have already used good quality aluminium led solar road stud flashing know that although our Solar Led Road Studs have a very good warning effect on traffic roads, he also has a few pain points. What is it? Today, Weimei introduced the four major pain points of our Solar Led Road Studs after use:
good quality aluminium led solar road stud flashing are mainly divided into the following situations:
The first is that the battery is dead. The reason the battery is dead is that the solar panel is not charging and the LED has been working, so after all the battery power is consumed, it will not turn on. The solar panel is crushed. When the tissue component of the solar panel is crushed, the current cannot be charged into the battery. So for a long time, there is no way.
The second possibility is that the charge and discharge device is broken. The charge and discharge device of good quality aluminium led solar road stud flashing has a boost function and a buck function. When working, sensitive components are subject to some static electricity. It may be used for a period of time. In the future, some components were damaged, and his functions could not be achieved, so there was no way to charge, and there was no way to convert solar power into batteries.
The third is water ingress on the surface of the good quality aluminium led solar road stud flashing. This surface water ingress means that the LED lens is soaked by large water, and the water slowly penetrates around the LED wide angle. At the beginning, the LED is no problem, but the corner of the foot starts Rust, after a period of time, the LED will not turn on.
Can good quality aluminium led solar road stud flashing be pressed by the car?
In this case, the car is divided, and its own weight depends on whether the car is stationary or is accelerating in a dynamic state.
If the weight of the car is only less than two tons, and the whole body is pressed to the solar studs, he will not have too many problems. However, if it is a very heavy mud truck or a vehicle of some special types of work, it will be regarded as pressure. He won’t have a problem a few times, but after many times of rolling, the solar panel wafer may be damaged. For a long time, his quality can not reach, so it starts to turn off.
The second state is to install the good quality aluminium led solar road stud flashing in the middle of the road. Every time, there are many vehicles to crush the solar stud. In this case, it will start to turn off slowly.
How about the waterproof effect of the good quality aluminium led solar road stud flashing?
There are several types of the good quality aluminium led solar road stud flashing. The first is to put his lens on the surface of the solar stud. This requires the worker to be very careful and careful when operating the solar lens. It may not enter the water, but for a long time, when he is exposed to high temperature and cold winter, it may form glue and the shell phase will leave.
The other is to clip the retro-reflective lens in the solar rivet, and then use solar energy to fix the glue. The entire lens is stuck in it, poured and poured, so he will not have water. You can use it for two or three years. He will not have any problems. He has well protected the LED pins and well protected the LED from being slowly eroded by water.
Fourth, why the good quality aluminium led solar road stud flashing are not resistant to low temperature?
The good quality aluminium led solar road stud flashing uses a nickel-metal hydride battery. One of the very bad aspects of nickel-metal hydride batteries is that they are not resistant to low temperatures. When the low temperature exceeds -40 degrees Celsius, its battery will not function for an instant. Therefore, using solar studs, if it is not recommended because the temperature is too low, it must be used above minus 40 degrees Celsius. One solution is to use a lithium battery in the range of nickel-metal hydride batteries. solve this problem.
In addition to the good quality aluminium led solar road stud flashing, We also produces other road studs:
1.Circular solar road studs
2. Horseshoe solar studs
3.Plastic solar road studs
4.Cast aluminum solar road studs
5.Reflective studs
Post time: Dec-15-2020