High visibility LED 300mm yellow solar traffic warning lights

High visibility LED 300mm yellow solar traffic warning lights

The parameters of the 300mm solar yellow flashing lamp (with lens):
1. Product size: 350*350mm
2. Number of lamp beads: 75 yellow (with lens)
3. Lightning diameter: 300MM
4. Lamp Beads Category: Taiwan Crystal Chip Lamp Beads
5. Yellow wavelength: 590-595NM
6. Solar panel: 8W/18V
7. Service life: 100000H
8. Shell material: PC
9. Battery: 8AH/16AH
10. Working temperature: -40 ° C -65 ° C
11. Protection level: IP53
12. Working voltage: DC12V
13. Working mode: flashing
14. Visual distance: ≥600M

The characteristics of 300mm solar yellow flashing lights (with lens):
1.300 type solar yellow flashing lamp (with lens) adopts Taiwan crystal chip lamp bead, high brightness, high refresh rate

and long service life.
2.300mm solar yellow flashing lamp (with lens) adopts 8W/18V solar panel, which uses solar energy to generate electricity,

which is energy-saving and environmentally friendly.

3.300mm solar yellow flashing light (with lens) sunshade is made of PC material, which has better waterproof and dustproof

effect and simple installation.
4.300mm solar yellow flashing light (with lens) uses 12V 8AH super large lead-acid battery, more powerful power storage, can

better cope with the rainy weather.
5. The 300mm solar yellow flashing lamp (with lens) is green energy, economical and environmentally friendly, contains no

harmful substances, and does not emit pollutants.
6. The 300mm solar yellow flashing light (with lens) has a lens function, the light is more concentrated, and the warning

effect is more obvious.

Third, the installation method of 300mm solar yellow flashing lights:
1. Leave a screw on both ends and unscrew the nut on the screw.
2. Place the “L” bracket, the flat end, on the screw according to the hole position and the card slot, then insert the solar panel

bracket into the screw, then insert the gasket and nut, and tighten the nut. Finally, the solar panel pair connector and the

lamp pair connector can be docked.
3. The sun visor is installed on the upper part of the lamp, and the three-corner aluminum plate is folded into a circular arc

shape and placed on the lamp, and the screw is aligned with the corresponding hole position.
4. Make 2 holes on the signal light rod, drill holes according to the hole position of the L bracket of the signal lamp, pass the

light rod through the appropriate screw, and put the L-shaped bracket on the screw and fix it with the nut.

If you are interested in our product,Please fell free to contact with us