The installation method of Countdown timer traffic light

The installation method of Countdown timer traffic light

The detailed parameters of the driving school countdown timer traffic lights:
Model: WDM-DJ300-06 Mainly used for driving schools, crossroads and other places.
1. Product size: 1050*350*110mm (without decorative edge)
2. Number of lamp beads: 156 red and green plates, countdown to 64 red and green
3. Lightning diameter: 300MM
4. Lamp Beads Category: Taiwan Crystal Chip Lamp Beads
5. Red wavelength: 620-625NM
6. Green wavelength: 500-505NM (blue-green) 520-525NM (green)
7. Visual distance: ≥1000M
8. Service life: 100000H
9. Shell material: PC
10. Illumination angle: 30°
11. Working temperature: -40 ° C -75 ° C
12. Protection level: IP55
13. Working voltage: AC85V-265V A small amount of DC12V/24V
14. Rated power: red 18W green 22W

The driving school countdown timer traffic lights features:
1. The driving school countdown timer traffic light adopts Taiwan crystal chip lamp beads, high brightness, high refresh rate and

long service life.

2, driving school countdown timer traffic lights on the back of the design has a hole, not only easy to outlet, but also has a good

waterproof effect.

3, driving school countdown timer traffic light sunshade is made of PC material, has a good waterproof and dustproof effect, easy

to install

4. Each lamp and lamp of the driving school countdown timer traffic light adopts the snap-lock design, which facilitates the inspection

and maintenance of the product.

Third, the driving school countdown timer traffic lights physical map:

The driving school countdown TIMER traffic lights installation method:

1. Leave a screw on both ends and unscrew the nut on the screw.

2. Put the “L” bracket, the flat end, according to the hole position and the slot on the screw, tighten the nut

3. The sun visor is installed on the upper part of the lamp. The three-corner aluminum plate is folded into a circular arc shape, which is

placed on the lamp and screwed to the corresponding hole to tighten.

4. Make 2 holes on the signal light rod, drill holes according to the hole position of the L bracket of the signal, pass the light rod through

the light rod with the appropriate screw, and put the L-shaped bracket on the screw and fix it with the nut.

If you are interested in our product,Please fell free to contact with us